This is a 3.0 Mitsubishi with drive by wire and has map and the post cat o2 sensor.
After re-grooving deeper, and driving about 2500 km the average savings calculated to 20.444%.
This week I decided to install the mapster.I have verified the proper wiring.
I now have an error code that states CIRCUIT HIGH INPUT SENSOR A. P0123
While the orange light is not on, my OBD2 can not reset the error code.
The readings are:
to MAP 0.89 v
to ECU 1.78 v
AT IDLE TPS 15.6 TO 16% RPM FROM 739 TO 810
I have tried adjusting the mapster to lower the TPS% but then the van does not perform well.
Original idle tps was 25%, lowest I could get it was about 16% and still have a little throttle response.
This is the second mapster, the first one, on a pontiac 3500 drive by wire, the TPS% was around 5% at idle and 15 to 16% going 100km.
Any suggestions will be appreciated.
Thanks
Glen
